Wednesday, November 4, 2015

Recipe - squirrel stew

Makes 2 servings

2 squirrels
2c water
2 cubes chicken bullion

2 carrots
2 stalks celery
1 potato
1 can diced tomatos


Put the squirrel, water, and bullion in the pressure cooker and put on high heat.
When the cooker gets up to temp, reduce heat to medium and set timer for 20 min.
Peel and chop the carrots, potato, and celery.
When the timer is done, take the pot to the sink and run cool water to release the pressure.
Remove the squirrel and place in a colander.
Rinse with water until it's cool enough to handle.
Pull the meat off the bones and put back in the pot along with everything else.
Put pressure cooker on high heat.
When the cooker gets up to temp, reduce heat to medium and set timer for 15 min.
When the timer is done, take the pot to the sink and run cool water to release the pressure.

Recipe - Squirrel and dumplings

Makes two servings

2 squirrel
4c water
4 cubes chicken bullion

2 carrots
2 stalks celery

1 egg
1/3c milk
1c flour
1ts montreal chicken seasoning
1ts baking soda
1ts baking powder

Put the squirrel, water, and bullion in the pressure cooker and put on high heat.
When the cooker gets up to temp, reduce heat to medium and set timer for 20 min.
Peel and chop the carrots and celery.
Mix the dumpling ingredients together and roll flat on a floured surface.
Cut into 1/2" cubes with a pizza slicer.
When the timer is done, take the pot to the sink and run cool water to release the pressure.
Remove the squirrel and place in a colander.
Rinse with water until it's cool enough to handle.
Pull the meat off the bones and put back in the pot along with the carrots and celery.
Take back to the stove and get to a rolling boil.
Drop the dumplings in and stir.
Reduce heat to 1/3 for 15 minutes stirring occasionally.

Wednesday, April 22, 2015

04/21/15 Fishing Report

Lake: Beaver
Location: Highway 12
Time: 4:00PM-7:00PM
Air temp: 60 degrees
Water temp: 61 degrees
Clarity: Clear
Visibility: 5'
Wind: W 5-20
Sky: partly cloudy
Winning tactic: Jigging 1/16th oz  swimming minnow on brush in 20 FOW.
Catch: 28 crappie, 1 bluegill, 1 striper

We picked up right where we left off last Tuesday. We came back to the lay down tree on the roadbed. We would cast out, count to ten, and slow roll light colored jigs on 4lb line bumping the top of the limbs. During a lull, we went over to a point to check out some surface action and picked up a 19" striper on an ultralight rig. They seemed to bite more when the sun was out between the clouds. Hopefully the rain and tournaments don't mess up the bite.

Monday, April 13, 2015

04/11/15 Fishing Report

Lake: Beaver
Location: Highway 12
Time: 7:00AM-3:00PM
Air temp: 60 degrees
Water temp: 55 degrees
Clarity: Clear
Visibility: 5'
Wind: SW 10
Sky: overcast
Winning tactic: Trolling Flickershad in 17' of water.
Catch: 25 crappie, 25 whites, 3 bass, 2 bluegill, 1 walleye

We finally got a big boat with all the right stuff. We had 7 rods going at one time covering about 100' wide and 5'-15' deep. The planer boards doubled the amount of lines we could have out and also kept them from getting tangled. There was an area about 200x200 yards in about 35' of water that had bait from 15' to the bottom. We drifted brooder minnows for a while trying to pick up a striper, but no luck. We started trolling flicker shad behind planerboards and pick one up about every 15 min. At one time we had three on at the same time. Daniel caught two on the same crankbait. We were trolling slow enough that you could still cast a little off the front. Daniel picked up a couple white bass on the bank so we started casting for a bit and picked up a dozen or so before they had to leave. Needless to say it was a great day.



 








Wednesday, December 3, 2014

Story - 2009 Highline Pistol Doe

I was sitting in a tree with the 7mm waiting for some deer to walk by. I had a doe walking perpendicular to me at about 100 yards. I was going to follow her with the crosshairs and try to shoot her, but I decided to hold the crosshairs still and shoot when she walked through them. I shot and she ran off into the pine field. I called Robert to come help me. After getting down and looking, we couldn't find any blood. Robert made a loop into the pines to see if he could find anything. I looked to my left and saw her about 30 yards away staring at me. I pulled up the 7mm and shot for the neck. She fell, but got right back up and started running perpendicular to me with both front legs tucked under. I pulled out the pistol and shot a couple times. One hit her in the chest and we found the bullet lodged in the opposite shoulder. It hadn't expanded like it was supposed to. It crumpled thef front corner and tumbled, but it did the job. 
 

 

Homemade lighted arrow nock

 I have always wanted a lighted arrow nock, but I didn't want to pay $10 each for them. We tried making our own for about $4 each using the Thill bobber light. Mark your nock and arrow to be sure that they are aligned when you put them back together. Drill out your nock large enough for the bobber light to fit. Cut the section that goes inside the arrow in half. Glue the tip of the bobber light in the outer portion of the nock. Glue the base of the light to the inner portion of the nock. Sand down the outer portion of the nock on the half with the light tip so that it doesn't have as much resistance when going into the arrow. Push the rear portion in a click to the on position and insert into the arrow. With it fully seated, you should be able to pull it out a click to turn it off.. You need to use a gel type glue so it doesn't run down and seize up your switch. I used gorilla glue because it is what I had, but I didn't realize that it expanded when it dried.












Monday, December 1, 2014

11/26/14 Gun hunt

Brent called me up and asked if I wanted to run out into the woods before Thanksgiving. It didn't take much arm twisting for me to agree and set up a plan. We decided to really try to film a hunt. We were going to climb the same tree with me filming above and him hunting below. I had the 22 with the camcorder and iphone strapped to it in case we got attacked by squirrels and he had the slug gun. We got out with plenty of time before sunrise. The place we went has a steady uphill walk from the get-go. About halfway to the tree I was ready for a break, but I didn't want him to think I was a wuss, so I trudged on. When we got to the tree Brent said "I wish we would have taken a little breather back there." I started up the tree and he followed behind. A little after shooting light the squirrels came out, but it was too dark to see through the viewfinder. About an hour after being in the tree we heard a deer behind us coming out of the brush about 50 yards away. I spun around and started filming. I realized right away that the camcorder was too far forward to really see the viewfinder well. Also, my phone ran out of storage so it shut off on it's own. I was trying to keep up with the deer, but more kept coming down the trail. I think we counted at least 6. They were milling around and I couldn't tell which one he was wanting to shoot. We were really too far away from each other to talk with the deer that close. I peeked down at him a few times, but couldn't really tell where he was aiming. Once, he tried to shoot, but he forgot to take off the safety. We just happened to be on the same deer when he squeezed one off. It ran back the way they had come and the other deer slowly followed in the same direction. You can hear the deer crash in the video. After the area was clear, we started to climb down. We weren't exactly trying to be quiet. We crunched our way up to the trail while talking and both spotted another deer at the same time. Brent took the camera and I took the slug gun. I kept inching to the right until I had a clear shot on the chest. It dropped. Back at the house, I was wanting to try skinning them with the electric hoist. It seemed to bog down a lot in the 220lbs mode, so I think next time I am going to double the cable back to get 440lbs. I am also going to try to skin them back legs first to see if that keeps the neck cleaner. I think that would also help cut the ribs out since the bottom is flat.